EZ Digital OS-3060D Instrucciones de operaciones descargar pdf (Pagina 40)

39

If you want to print out (plot) a speciﬁc screen

content in storage mode, press the HOLD button

in the STORAGE MODE panel. Plotter output is

then possible. Printout is initiated by pressing

the PLOT button in the STORAGE MODE panel.

During printout, the LED under the cap of the

PLOT button is lit. Once printing has ﬁnished,

the LED goes out again.

2.4.5 Troubleshooting if plotter does not

work:

a) The connecting cable between the oscillos-

cope and plotter was not connected/plugged

in or was connected/plugged in incorrectly.

b) The plotter may be switched off.

c) DIP switch No. 1 is incorrectly set.

d) You forgot to press the HOLD button in

storage mode.

e) The baud rate and the data format do not

match the plotter manufacturer's settings.

3. Maintenance and

Care

Warning!

It is crucial to observe the safety instructions

given under heading 1.2 when carrying out

maintenance or repair.

Use a dry, lint-free, antistatic cleaning cloth to

clean the oscilloscope.

Note

Never use any solvents that contain hydro-

carbons, e.g. petroleum spirit or thinners to

clean the housing. They release toxic vapours,

create risk of explosion in the event of sparking

and will damage the surface of the oscilloscope.

In order to remove dust or dirt from the anti-

glare ﬁlter or the surface of the CRT screen, use

a suitable screwdriver for slotted screws to

carefully remove the two pins in the bottom

edge of the front cover (they are made of

plastic), carefully swivel the cover forward from

the top (see ﬁgure below). Use a mild glass

cleaning solution to clean the anti-glare ﬁlter

and the screen surface. Before reassembling,

make sure that your ﬁngers have not touched

the surface of the screen or the anti-glare ﬁlter

(ﬁnger marks) and that everything is dry.

Anti-glare filter

Front cover

Fig. 24

1 2 ... 35 36 37 38 39 40 41 42 43 44

Comentarios a estos manuales

Sin comentarios