EZ Digital OS-3060D Instrucciones de operaciones descargar pdf (Pagina 25)

Fig. 13

Typical settings:

a) Set the Vertical switch to the CH 1 position

b) Press the HOLD button

c) Use the Menu button to select the AMAG OFF

sub-function and use the SELECT button to

switch it on ( AMAG ON.

d) Expand once as described in 9a or 9b.

e) The expanded signal waveform is displayed

roughly 3 div underneath the non-expanded

signal.

(12) Go-NoGo mode

The Go-NoGo sub-function is useful for the

assessment of signals. Each displayed "pixel" of

the signal waveform is "extended" upwards and

downwards by a speciﬁc amount. The following

"lengths" can be set: +/-0.4 div, +/-0.8 div or

+/-1.2 div. To select or set this sub-function,

proceed as follows:

a) In storage mode, press the MENU button until

"G-NG XH=>OH" appears at the top edge of

the screen in the middle.

b) Press the RECALL button once.

c) "0.4 div" appears instead of "XH=>OH". This

value can then be modiﬁed by pressing the

SELECT button (under MENU).

d) Then set the desired "assessment area".

e) Finally, to run the function, press the RECALL

button again.

(11) AMAG operating mode = ALT MAG

In this operating mode, both the "normal" stored signal waveform and the expanded signal waveform

of the relevant channel that was previously set, e.g. CH 1, are displayed simultaneously or alternately

= ALT.

To display CH 2, Vertical switch (18) must ﬁrst be set to CH 2.

Note the following Table:

CH 1 CH 1-signal CH 1 signal + expanded CH 1 signal

CH 2 CH 2-signal CH 2 signal + expanded CH 2 signal

DUAL CH1- and CH2-Signal CH1 and CH2 signal, both channels

expanded

ADD CH1- + CH2-Signal The result of adding CH1 + CH2 at

the same time as the "expanded"

result.

Switch position Normal indication (not storage)

AMAG mode

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 43 44

Comentarios a estos manuales

Sin comentarios

EZ Digital OS-3060D Instrucciones de operaciones Pagina 25

Comentarios a estos manuales